JRR Dodge Viper 1996-2002 MoTeC M130 PNP Kit
-
The M130 kit plugs right in to your Viper and provides a powerful tuning solution. A start up calibration customized to your setup is included.
-
This kit fits 1996-2002 Dodge Viper vehicles
-
The OE PCM is retained in a piggyback configuration to maintain security system and chassis electronics functionality with the older Dodge communication protocol while the M130 takes full control of the engine operation.
- Spare inputs and outputs pinned to a 12 way DTM connector
-
Flex fuel control - adjust fuel, timing, boost, cold start and more based upon ethanol content
-
Nitrous control - various parameters supplied to control nitrous. Includes nitrous bottle heater relay control based on nitrous pressure
-
CO2/wastegate pressure control - controls a fill/bleed solenoid setup to control wastegate pressure
- Knock control is available with the addition of sensors (OE car does not have them)
-
Water injection control - with failsafe for boost/timing/fuel based on pressure sensor feedback
-
Air bypass anti-lag control - for increased ALS performance (when used with appropriate engine hardware)
-
Boost control system allows incorporating turbo shaft speed and turbo compressor inlet pressure into the control strategy
-
Supports the use of third party lambda controllers with 0-5v output
-
Supports momentary buttons
-
Supports direct input from a MoTeC/Racegrade CAN keypad
-
Like anything, the MoTeC M1 requires knowledge and experience to gain the best results. While we are happy to answer technical questions, purchase of this M1 kit does not come with unlimited tuning support. We can quote tuning for your particular setup, refer you to someone in your area, or if you prefer to do it yourself (and lack the experience) then we can also quote training.
-
This ECU kit is for closed course competition vehicles only. It does not meet federal emissions requirements.
- THIS ITEM IS SPECIAL ORDER AND IS BUILT TO ORDER!